Alto-Shaam ASF-60E Fryer User Manual


  Open as PDF
of 70
 
Electric Fryer Operation & Care Manual • 40
DELUXE CONTROL OPERATION
PROGRAMMING THE CONTROL
“LO BAND”
“LO BAND” provides an alarm notification when the temperature of
the oil is lower than the set-point temperature. The adjustment range is
between5°Fand100°F(3°Cand56°C)withafactorypresetof21°F(12°C).
Press the Up or Down arrow keys to scroll until “LO BAND” appears in the display. Press
the Right4arrow key to enter the program. Display stops flashing. Press the Up or
Downarrowkeystoscrolluntilthedesirednumberappearsinthedisplay.When
the desired setting appears, press the Right4 arrow key to accept the selection. Display
flashes. Press the Down arrow key to advance the control to the next programming
function.
“HI BAND”
“HI BAND” provides an alarm notification when the temperature of the
oil becomes higher than the set-point temperature. The adjustment range
isbetweenzeroand100°F(56°C)withafactorypresetof25°F(14°C).
Press the Up or Down arrow keys to scroll until “HI BAND” appears in the display. Press
the Right4arrow key to enter the program. Display stops flashing. Press the Up or
Downarrowkeystoscrolluntilthedesirednumberappearsinthedisplay.When
the desired setting appears, press the Right4 arrow key to accept the selection. Display
flashes. Press the Down arrow key to advance the control to the next programming
function.
“MELT CT”
The fryer control includes a melt function with ON/OFF pulsed heating cycles for the
purpose of melting solid shortening at a continuous but slower rate to assure full melt-
down. The operator has the ability to control the ON/OFF pulse rate between 00:01 and
00:60seconds.Thefactorydefaultissetfor10seconds(00:10).
Press the Up or Down arrow keys to scroll until “MELT CT” appears in the display. Press
the Right4arrow key to enter the program. Display stops flashing. Press the Up or
Down arrow keys to scroll until the desired time appears in the display. Whenthe
desired setting appears, press the Right4 arrow key to accept the selection. Display
flashes. Press the Down arrow key to advance the control to the next programming
function.
The “PREHEAT BAND” is used to prevent the oil temperature in the frypot from
reaching the actual set-point temperature in order to compensate for temperature override
asthefryercallsforheat.Thisprogramfeatureissetto10°F(6°C)atthefactory.
It is strongly urged that the “PREHEAT BAND” remain at this setting.
0:10
Melt Ct
10°F
Preheat Band
25°F
Hi Band
Hi Temp
“PREHEAT
BAND”
To exit the control programming mode, press and hold the LEFT arrow key.
Low Temp
21°F
Lo Band
 previous next