Filter
Top Products
Electric Fryer Operation & Care Manual • 38
DELUXE CONTROL OPERATION
PROGRAMMING THE CONTROL
“FILTER”
The filter program is a monitor to notify the operator to service the oil/shortening after
a specified number of product loads established and set in the filter count “FILTER
CNT” programming function. This feature is set to “OFF” at the factory. THE NUMBER
OF PRODUCT LOADS CAN BE ADJUSTED BY THE OPERATOR THROUGH THE FILTER COUNT
PROGRAM. FILTER COUNT WILL AUTOMATICALLY ADJUST FILTER MONITOR ALERTS TO ONE OF
THE THREE SELECTIONS SHOWN AS SET BY THE OPERATOR.
“Off”
Whensettothe“OFF” position, the filter monitor is disabled and will
not notify the operator to service the oil/shortening.
“ALRM” Set to alarm “ALRM,” this feature will provide an audible
alarmandthedisplaywillindicate“FILTERNOW”asa
reminder to the operator after every 15 product loads or
the number of processed fry loads set by the operator in the “FILTER
CNT”programfunction.Whensetto“ALRM” additional fry loads can be
processed and the alarm can be silenced by pressing the ON/OFF power
key on the main control panel to the “OFF” position
“LocH”
Whentheprogrammodeischangedtothelock“LOCH” position, an
audible alarm will sound and the fryer will become inoperable following
the number of processed fry loads set by the operator in the “FILTER
CNT” program function. The control will only become operable after the
oil/shortening has been serviced.
Press the Up or Down arrow keys to scroll until “FILTER” appears in the
display. Press the Right4arrow key to enter the program. Display stops
flashing. Press the Up or Down arrow keys to toggle among the
availablechoices.Whenthedesiredsettingappears,presstheRight4
arrow key to accept the selection. Display flashes. Press the Down
arrow key to advance the control to the next programming function.
A LRM
Filter
L OCH
Filter
OFF
Filter
OFF
Filter
Filter Now
To exit the control programming mode at any time, press and hold the LEFT arrow key.