Amana ART6710 Range User Manual


 
19
Removing Oven Door
CAUTION
To avoid personal injury or property damage, handle
oven door with care.
Door is heavy and can be damaged if dropped.
Avoid placing hands in hinge area when door is
removed. Hinge can snap closed and pinch hands.
Do not scratch or chip glass, or twist door.
Glass may break suddenly.
Replace door glass if damaged.
Do not lift door by handle.
1. Open door fully.
2. Remove screws.
Oven doors are attached with a screw on each side
of lower oven door.
3. Close door to first stop, grasp door firmly on each
side, and lift upward until door is off hinges.
(Figure 18)
Do not lift door by handle. Glass can break.
Only push hinges closed once oven door is
removed if necessary. Use both hands when
closing hinge. Hinge snaps closed.
Figure 18
Removing Storage Drawer
1. Slide drawer out until it stops.
2. Grasp drawer sides near back of drawer. (Figure 19)
3. Lift up and out.
Reverse to reinstall.
Care and Cleaning
Replacing Oven Light
WARNING
To avoid risk of burns or electrical shock, disconnect
electrical supply to oven before changing light bulb.
Before replacing light bulb make sure bulb is cool.
Wear protective gloves.
Do not operate oven without bulb and cover in place.
1. Disconnect electrical supply.
2. Remove oven door if desired.
3. Unscrew light bulb cover located in rear of oven
cavity. Then turn light bulb counterclockwise to
remove. (Figure 20)
4. Replace light bulb with 120-volt, 40-watt appliance
bulb.
Do not overtighten bulb or it may be difficult to
remove later.
5. Replace light bulb cover and oven door before use.
6. Reconnect power supply.
Figure 20
Replacing Fluorescent Light Bulb
(Some Models)
1. Lift up on front edge of backguard top trim. Flip top
trim towards rear of backguard. (Figure 21)
2. Twist fluorescent bulb to remove it from sockets.
CAUTION
Wear gloves to protect hands from accidental bulb
breakage.
Lift
Figure 21
Figure 19