Filter
Top Products
14
Dispenser Features
Primary Features
Dispenser Light not shown
A light activates within the dispenser area at full power when dispensing ice or water.
Front Fill Button (some models)
The Front Fill button works independently of the dispenser controls, providing an up-front
alternative to the dispenser pad for dispensing water. This feature is convenient for filling
large items that will not fit into the dispenser area (i.e. sport bottles, pitchers, large pans,
coffee pots).
This feature allows added convenience of dispensing ice and water simultaneously.
To use, choose your preferred ice mode from dispenser control panel. Press container
against dispenser pad while pressing the Front Fill button.
Dispenser Pad
The dispenser pad is located on the back wall of the dispensing area. When the dispenser
pad is pressed, the selection chosen on your dispenser control panel will dispense.
Removable Tray
The removable tray at the bottom of the dispenser area is designed to collect
small spills and may be easily removed for cleaning and emptying purposes.
IMPORTANT: Removable tray does not drain. Continuous water
running into tray will cause tray to overflow.
CAUTION
!
To avoid personal injury or property damage, observe following instructions:
Do not put fingers, hands, or any foreign object into dispenser opening.
Do not use sharp objects to break ice.
Do not dispense ice directly into thin glass, fine china, or delicate crystal.
NOTE: During initial use of water dispenser, allow an approximate 1-2 minute delay in water
dispersal to allow internal water tank to fill. Discard first 10-14 containers of water after initially
connecting refrigerator to household water supply and extended periods of nonuse.
To use dispenser pad:
Choose water selection from dispenser control panel.
Press sturdy, wide-mouthed container against dispenser pad.
Release pressure on dispenser pad to stop water from dispensing. A small amount of
water may continue to dispense, and collect in dispenser tray. Large spills should be wiped dry.
To use Front Fill button (some models):
Align container under Front Fill button using blue water droplet as guide.
Press and hold Front Fill button.
Release button when desired fill is reached. A small amount of water may continue
to dispense, and collect in dispenser tray. Large spills should be wiped dry.
NOTE: If water dispenser is active for more than 3 minutes, an automatic lock out sensor
will shut down power to dispenser area. See Automatic Lock Out for further information.
Water Dispenser Operation