Filter
Top Products
7
What if my doors are not aligned?
• Locate the higher door, and turn front adjustment screw
counterclockwise. Continue until doors are level.
• If bottom of adjustment range is reached, and doors are
not level–raise opposite door by turning front adjustment
screw clockwise.
• Replace toe grille
Turn both front adjustment
screws (A) clockwise to raise
and counterclockwise to
lower.
2
Remove toe grille and bottom hinge covers
(see previous instructions).
1
CAUTION
!
To avoid damage to walls and flooring, protect soft vinyl or other flooring with cardboard, rugs, or other protective material.
To avoid damage or breakage to adjusting bolt, do not use power tools to correct leveling.
DO NOT adjust unit to be any shorter than 68 ½" inches tall (minus hinge and cap). Doing so may damage underside
components.
Turn both rear adjustment
screws (B) clockwise to raise
and counterclockwise to
lower.
3
Check with level to verify
1
/
4
" tilt to the
back for proper door closure.
If unit is aligned and stable, replace toe grille.
4
How to Level Your Refrigerator
Materials Needed
3
/
8
" hex head driver Level
What if my unit rocks?
• Turn rear adjustment screw clockwise to raise rocking
corner.
• Replace toe grille.
Installing Your Refrigerator
Confirm secure attachment by pulling on
tubing.
3
Turn on water supply and
correct any leaks.
Create service loop with remaining
tubing and attach to unit with "P"
clamp as illustrated. Avoid kinks.
4
How to Connect the Water Supply continued
How to Adjust the Temperature Controls
This refrigerator is designed to operate at a household temperature of 55° to 110°F (13° to 43° C).
IMPORTANT: Due to design of unit, always start temperature
adjustments with freezer section.
Allow 24 hours for temperatures to stabilize.
2
Check to see if freezer temperature is 0° to
2° F (-17° to -16° C).
3
Turn control to next highest number if too warm.
Turn control to next lowest number if too cold.
Allow 5 to 8 hours for adjustments to take effect.
Locate refrigerator and freezer controls on
upper left wall of fresh food section, and
set both controls to 4.
1
Check to see that fresh food section
is 38° to 40° F (3° to 4° C).
4
Repeat process, as necessary.
5
IMPORTANT: Neither section will cool if freezer control is
set to Off.
Materials needed
• 2 thermometers measuring -5° to 50°F (-21° to 10°C)
• 2 drinking glasses
How do I perform a temperature test?
Turn control to next highest number if too warm.
Turn control to next lowest number if too cold.
Allow 5 to 8 hours for adjustments to take effect.
For Freezer
• Place thermometer in glass
of vegetable oil in middle
of freezer and continue
with step 3 of Temperature
Adjustment section.
For Refrigerator
• Place thermometer in glass
of water in middle of unit
and continue with step 3
of Temperature Adjustment
section.
r
R
e
r
r