Amana DRS2663BB Refrigerator User Manual


 
17
WARNING
!
To avoid electrical shock which can cause severe personal injury or death,
disconnect power to refrigerator before replacing light bulb. After replacing light
bulb, connect power.
CAUTION
!
To avoid personal injury or property damage, observe the following:
Allow light bulb to cool.
Wear gloves when replacing light bulb.
How to Get the
Most Out of
Your Energy
Dollar
When placing refrigerator into final
position, allow for 1" clearance
around the top and sides of unit to
supply ample ventilation for
optimum energy efficiency.
Avoid overcrowding refrigerator
shelves. This reduces effectivity of
air circulation around food and
causes refrigerator to run longer.
Avoid adding too much warm food
to unit at one time. This overloads
compartments and slows rate of
cooling.
Do not use aluminum foil, wax
paper, or paper toweling as shelf
liners. This decreases air flow and
causes unit to run less efficiently.
A freezer that is
2
/
3
full runs most
efficiently.
Locate refrigerator in coolest part of
room. Avoid areas of direct sunlight,
or near heating ducts, registers, or
other heat producing appliances. If
this is not possible, isolate exterior
by using a section of cabinet or an
added layer of insulation.
Refer to owner's manual section on
temperature controls for
recommended control settings
Clean door gaskets every three
months according to Owner's
Manual cleaning instructions. This
will assure that door seals properly
and unit runs efficiently.
Take time to organize items in
refrigerator to reduce time that door
is open.
Be sure your doors are closing
securely by leveling unit as
instructed in your Owner's Manual.
Clean condenser coils of as
indicated in the owner's manual
every 3 months. This will increase
energy efficiency and cooling
performance.
How to Remove and Replace Light Bulbs
Hints and Care
Upper fresh food section
1. Locate finger gaps on each side of clear light
shield. Insert fingers and press in on each side
of shield. Pull shield down and remove.
2. Remove light bulbs.
3. Replace with appliance bulbs no greater than
40 watts.
4. Replace light bulb cover by inserting front tabs of
light shield into holes in liner directly in front of light assembly.
Lower fresh food section and
Non-dispensing model freezer section
1. Pinch bottom tabs (A) on light cover and pull straight
out.
2. Remove light bulb.
3. Replace bulb with appliance bulb no greater than 40
watts.
4. Insert top tabs (B) of light cover into refrigerator liner and
snap bottom portion over light assembly.
Dispensing model freezer section
1. Remove ice bin by lifting front of bin and pulling out.
2. Remove light bulb cover by pinching top tab (A) and
pulling cover out of liner.
3. Remove light bulb. Replace with appliance bulb
no greater than 40 watts.
4. Insert bottom tab (B) of light cover into liner and snap
top portion over light assembly.
5. Replace ice bin by sliding in until bin locks into place.
Ice N Water dispenser
1. Locate light bulb inside top edge of dispenser frame. Unscrew
to remove.
2. Replace light bulb with a 6-watt, 120 volt bulb.
A
B
$