Filter
Top Products
56
Care and Cleaning
Interior, Exterior and Door
If walls and door of microwave oven become
splattered, wipe with paper towel or clean with mild
detergent in warm water using soft sponge or cloth.
Wring sponge or cloth to remove excess water
before wiping unit. If desired, boil a cup of water in
microwave oven to loosen soil before cleaning.
Before cleaning oven floor, remove turntable and
turntable support. Plug hole in oven floor (see
diagram below).
• Do not use cleaners containing ammonia.
These could damage finish.
• Never pour water into microwave oven bottom.
• Do not use water pressure type cleaning
systems.
Discharge Air Vents
There will be a slight buildup of cooking vapors
along discharge louvers in back of oven on right
side. Clean air vent with damp cloth and dry.
Splatter Shield
Splatter shield keeps top of microwave oven and
antenna from getting soiled. Remove soil from
shield with damp cloth. Remove splatter shield to
clean more thoroughly.
Important
When removing and replacing splatter shield, be
careful not to bend antenna.
1. Unplug oven before removing splatter shield to
stop antenna from rotating.
2. Shield snaps into lip in front of microwave oven
and three slots in back. To remove, place
thumbs into two indentations in front of shield.
Press lightly toward back and carefully lower
shield away from antenna.
3. Pull shield forward, out of back slots and out of
microwave oven.
4. Wash shield in warm soapy water.
5. Dry and replace.
Important
• Do not wash splatter shield in dishwasher.
• Do not use abrasive cleaners.
Turntable
Wipe up spills immediately. Wipe with paper towel
or damp cloth. Remove turntable and turntable
support to clean more thoroughly. Place plug into
hole in oven floor (see diagram below). Wash
turntable and turntable support carefully in warm
sudsy water, rinse and dry thoroughly. Do not drop
glass turntable. When replacing turntable support,
support may need to be rotated one complete turn
to engage into drive mechanism.
Important
Do not wash turntable support in dishwasher.
Tools needed--
• protective gloves
• flat blade screwdriver
• 120 volt, 40 watt,
appliance bulb (usually found at grocery or
hardware stores)
Replacing Oven Light Bulb
Caution
To avoid electrical shock hazard
unplug power cord or open circuit
breaker to microwave oven before
replacing light bulb. After replacing
light bulb, reconnect power.
Important! Wear gloves to protect hands should
light bulb break. If hot, allow bulb to cool.
To change oven light bulb:
1. Remove access screw from and open access
cover on top left wall of oven exterior.
2. Remove bulb, being careful not to burn fingers
or break bulb.
3. Replace bulb.
4. Replace access cover and replace access
screw. Do not operate oven with access cover
removed.
5. Restore power to microwave oven.