19
AUS
Care and Cleaning
DO NOT TOUCH HOT SURFACES. ALLOW
COOKTOP AND ALL OVEN SURFACES TO COOL
COMPLETELY BEFORE CLEANING.
! Never use steam cleaners or pressure cleaners
on the appliance.
!
Clean the glass part of the oven door using a sponge
and a non-abrasive cleaning product, then dry
thoroughly with a soft cloth. Do not use harsh abrasive
cleaners or materials, or metal scrapers to clean the
oven door glass since these can scratch the surface,
which may result in shattering of the glass.
! The accessories can be washed like averyday
crockery (even in your dishwasher).
! Switch off the electricity supply and allow to
cool before cleaning the cooker.
! Clean the cooker regularly and wipe up spills
soon after they occur to prevent them from
becoming burnt on. Never use biological
washing powder, caustic cleaners, harsh
abrasives, scouring pads, steam cleaners,
aerosol cleaners or oven chemical cleaners of
any kind.
! Before moving your cooker ensure that it is cool
and note that it is heavy so you may require
assistance. The cooker is fitted with rear wheels and
will slide in and out of position easily.
Movement of your cooker is most easily achieved as
follows:
Open the grill/oven door sufficiently to allow a
comfortable grip on the underside front edge of the
oven roof, avoiding contact with any grill or oven
furniture and then lift and slide at the same time.
When repositioning the cooker, ensure that it is
level. Take care to ensure that any floor covering is
not damaged.
Cleaning The Cooktop
" Always wipe spills up when they occur. Do not
leave spills to dry onto the surface of the hob.
" It is usually enough to wash the hob with a damp
sponge and dry it with absorbent kitchen roll.
" NOTE: Do not put hot components in cold water.
The sudden temperature shock could cause the
component to crack.
" Do not use abrasive or corrosive detergents such
as stain removers, anti-rust products, powder
detergents or sponges with abrasive surfaces:
these may scratch the surface beyond repair.
Burners
" Wait for the cooktop to cool completely. Remove
the burner cap and check the gas outlet holes for
blockages. Clean with a soft bristle brush and
warm soapy water.
" The removable parts of the burners should be
washed frequently with warm water and soap and
any burnt-on substances removed.
" Dry the burner parts thoroughly before replacing.
Ignitors
" The terminal part of the electronic instant lighting
devices and flame failure probes should be
cleaned frequently,
'HEAT CLEAN' LINERS
The oven linings are coated with a special enamel
which has a continuous cleaning action. The higher
the oven temperature the more effective the action.
In most cases this cleaning operation will proceed
during normal cooking.
However, if high temperatures are not used regularly
it may be necessary to run the oven empty at
maximum setting for one hour. If desired, they can
be wiped over with a soapy cloth followed by a wipe
with a clean, damp cloth.
Inspect The Oven Seals
" Check the door seals around the oven door
regularly.
" If the seals are damaged, please contact your
nearest Ariston Service Centre. We recommend
that the oven is not used until worn seals have
been replaced.
CLEANING THE GRIDDLE PLATE
After cooking, leave the griddle plate on the hob and
allow to cool before cleaning. It can then be taken to
the sink and washed using warm soapy water,
gently wipe the cooking surface with a dishcloth. DO
NOT use abrasive cleaning materials.
REPLACEMENT OF OVEN LIGHT BULB
CAUTION: DISCONNECT THE APPLIANCE FROM
THE ELECTRICITY SUPPLY BEFORE
REPLACING THE LAMP TO AVOID THE
POSSIBILITY OF AN ELECTRIC SHOCK.
Light bulbs are not covered by the manufacturer's
guarantee.
A new 15W, 300°C rated SES bulb can be obtained
from your cooker supplier or any major electrical
retailer.
1. Remove the shelves from the oven.
2. Unscrew the lens using a thick cloth to protect your
fingers in the unlikely event of a lens fracture.
3. Unscrew bulb.
4. Fit new bulb and refit lens.