Filter
Top Products
26
AUS
Installation
CONVERSION FOR USE ON LPG
Each hob burner requires the injector to be replaced
and each burner gas tap to have the by-pass screw
adjusted according to the following procedure:
1. Lift off the burner cap and the burner body and
place it to one side.
2. Remove the injector from the burner base with a
suitable box spanner and discard.
3. Replace the injector with the appropriate
replacement (see Table on the previous page).
4. Repeat for each burner.
5. Replace the burner bodies and caps, taking care
that they are positioned correctly.
6. Remove the tap knob from the left hand hotplate
tap. Insert a narrow flat screwdriver centre of the
tap spindle and turn fully clockwise. Replace the
tap knob. Repeat this procedure with the other six
hotplate taps.
7. Position and fix the self-adhesive LPG conversion
label over the gas details on the rating plate label.
SPACE FOR FIXING
The diagram shows minimum clearances between
the cooker and adjacent walls, cupboards etc. The
dimensions of the appliance and the location of
connection points are provided in the Technical Data
section. It is recommended that the adjacent kitchen
surfaces should be capable of withstanding
temperatures of 65°C. Also, the following must be
observed:
" The appliance should be installed next to
cabinetry which is no taller than the top of the
cooker hob.
" The wall in direct contact with the back panel of
the cooker must be made of non-flammable
material. During operation of the cooker, the back
panel of the cooker could reach a temperature of
50°C above room temperature.
" Kitchen cabinets installed next to the cooker that
are higher than the top of the hob, must be at
least 600 mm from the edge of the hob itself.
The following minimum clearances to combustible
materials must be observed:
" Minimum clearance from edge of burner to side
wall must be 200 mm.
" Minimum clearance from edge of burner to rear
wall must be 200 mm.
" Minimum clearance from burner to overhead
cabinetry must be 600 mm.
Note: The rear wall clearance need not be observed
if the wall behind the cooker, 50mm below and
450mm above, and the width of the cooker are lined
with noncombustible material such as ceramic wall
tiles.
If the cooker is to be fitted close to a corner on the
left hand side, ensure that there is a clearance of at
least 50mm to allow the main oven door to open fully
for when removing oven shelves.
750mm min
Range hoods
Range hoods and overhead exhaust fans must be
installed according to manufacturers' instructions
but in no case shall clearance from hob burners be
less than 600 mm for range hoods and 750 mm for
overhead exhaust fans.
If the hood is installed below a wall cabinet, the
latter must be at least 700 mm (millimetres) above
the surface of the hob.
UNPACKING THE COOKER
Unpack the components from inside the grill and
oven. Check that the following parts are present:
Meat pan Pan supports (3)
Grill pan, grid and handle LPG conversion kit
Loose burner parts (14) Oven shelves (4)
Aluminium burner bodies (6) Griddle
Wok Stand Literature pack
After unpacking your cooker, make sure that you
remove all the packing from the oven and grill, and
any stickers from the oven door and the hob.