ELECTRICAL REQUIREMENTS
Before you insert the plug into the wall socket make sure that the voltage and the
frequency shown in the rating plate inside the appliance corresponds to your
electricity supply.
Rating label is on the left hand side of fridge inner liner.
We recommend that this appliance be connected to the mains supply via a
suitable switched and fused socket. The appliance must be positioned so that
the plug is accessible.
Should the mains lead of the appliance become damaged or should it need
replacing at any time, it must be replaced by a special purpose made mains lead
which can only be obtained from a BEKO Authorised Service Agent.
WARNING! THIS APPLIANCE MUST BE EARTHED
If the fitted moulded plug is not suitable for your socket, then the plug should be
cut off and an appropriate plug fitted. Destroy the old plug which is cut off as a
plug with bared cord could cause a shock hazard if inserted into a socket
elsewhere in the house.
The moulded plug on this appliance incorporates a 13 A fuse. Should the fuse
need to be replaced an ASTABEAB approved BS 1362 fuse of the same rating must
be used. Do not forget to refit the fuse cover. In the event of losing the fuse cover
the plug must not be used until a replacement fuse cover has been fitted. Colour
of the replacement fuse cover must be the same colour as that visible on the pin
face of the plug. Fuse covers are available from any good electrical store.
IMPORTANT! FITTING A DIFFERENT PLUG
As the colours of the wires in the
mains lead of this appliance may
not correspond with the coloured
markings identifying the terminals
in your plug proceed as follows:
(See diagram).
1. Connect the green-yellow or
green (Earth) wire to the terminal
in the plug marked 'E' or with
the symbol
or coloured
green and yellow or green.
2. Connect the blue (Neutral) wire
to the terminal in the plug
marked 'N' or coloured black.
3. Connect the brown (Live) wire to
the terminal in the plug marked 'L'
or coloured red.
With alternative plugs a 13 A fuse must be fitted either in the plug or adaptor or
in the main fuse box.
If in doubt contact a qualified electrician.
FITTED WITH
BS 1362 13A FUSE ALWAYS
FIT BS 1362 REPLACEMENT
CARTRIDGE FUSE
GREEN &
YELLOW
OR
GREEN
N
BLUE
OR
BLACK
L
BROWN
OR
RED
22mm.
6mm.
6mm.
6mm.
32mm.
12mm.
FUSE
CORD GRIP
3
2
CONTENTS PAGE
ELECTRICAL REQUIREMENTS 3
PLUMBING REQUIREMENTS 4
TRANSPORTATION INSTRUCTIONS 4
INSTALLATION INSTRUCTIONS 4-11
STARTING 12
STORING FRESH FOOD 13
FRIDGE COMPARTMENT STORAGE ADVICE 13
STORING PRE-FROZEN FOOD 14
GETTING TO KNOW YOUR FROST FREE FRIDGE FREEZER 15-16
USING THE ACCESSORIES 17-21
SUGGESTED ARRANGEMENT OF FOOD IN THE FRIDGE/FREEZER 22-23
TEMPERATURE CONTROL AND ADJUSTMENT 24-26
STORING FROZEN FOOD 27
FREEZING FRESH FOOD 27
DEFROSTING 27
CLEANING AND CARE 28
REPLACING THE INTERIOR LIGHT BULB 29
DO'S AND DON'TS 30
ENERGY SAVING TIPS 31
PROBLEM SOLVING AND TROUBLE SHOOTING 31-36
GUARANTEE DETAILS 37
HOW TO OBTAIN SERVICE 38