Filter
Top Products
10 / 11 EN
Hood / User Manual
5 Maintenance
C
Note:
Service your hood periodically!
Service is also required to prevent
burning of oil filter besides obtaining
better performance and better effi-
ciency.
5.1 Cartridge type oil filters
Cleaning
Cartridge type filters shall be cleaned every two
months in normal use. It may be cleaned in a
dishwasher or by hand using mild detergent or
liquid soap.
Cartridge type filters are easily removed, one at a
time, by pushing it slightly towards the rear of the
hood while pulling downwards (fig. 5).
Figure 5
C
Note:
There could be a possible fire hazard
if the filters are not replaced accor-
ding to these instructions
5.2.Carbon filters (optional):
In the recirculation mode the carbon filters absorb
smell and odors.
Carbon filters cannot be washed or regenerated.
They must be replaced every 2 months or more
frequently if the hood is used consistently.
Replacement:
• Dismantle the ducting support by pulling the two
knobs (A) (fig. 1) simultaneously to remove the
ducting grill.
• Replace the carbon filter.
• Close the ducting grill.
5.3 Cleaning the hood
• Hood must only be cleaned when it is
unplugged from mains outlet or when the fuse
is switched off!
• Hood must not be cleaned with a vapor cleaner
as it is not ensured that it would operate safely
afterwards due to water vapor.
Outer surfaces of the hood must be cleaned with
a mild cleaning agent (e.g. dish soap). Do not use
strong cleaning agents, abrasive agents or sharp
objects.
Stainless steel surfaces shall be cleaned with a
commercially available stainless steel cleaning
agent and a soft, non-abrasive sponge or cloth.
In order to prevent scratches, wiping action shall
be performed on the direction of surface structure
while you are cleaning the stainless steel surfaces.
5.4.Replacement of lamps
Illumination is made with 2 pieces of 28 W lamps.
If the lamps do not work, open the suction grille
and check that they are properly fitted. If the lamps
have burned out they must be replaced with new
ones at equivalent voltage and power.
Replacement:
28 W lamp (fig. 6): unscrew the burned out lamp
and fit the new one.
When replacing, ensure that the pins are correctly
inserted into the lamp holders.
Install the suction grille back.
Figure 6