Filter
Top Products
8 / 13 EN
3 Set-up
• Observe the dimensions given in Figure 1 and
drill 4 Ø 8 mm holes for X and Y and 4 Ø 6 mm
holes for Z and H.
• Use the screws and dowels in the equipment of
the appliance for installation of various parts.)
• Secure the bracket (Figure 2-3) to the Z and H
holes on the wall.
Place the screws to the Z holes so that a clearance
of 8 mm is left. (Figure 3)
After hanging the hood to the Y holes, secure it to
the wall using X holes inside the body. Tighten Y
screws. (Figure 4)
Hood / User Manual