Bloomfield WFAE-55F Fryer User Manual


 
363 30007 OpManual for WFAE-55F/FS Electric Fryer
MAINTENANCE INSTRUCTIONS - FILTER SYSTEM
25
IMPORTANT: Make sure all oil
is pumped into FRYPOT before
removing reservoir.
NOTE:
When properly assembled,
handle will point away from
suction tube on BOTTOM
SCREEN.
NOTE:
Inspect the “O” RING on
FILTER SUCTION TUBE for
damage. Replace “O” ring if it
is cut, cracked or scuffed using
one of the spare o- rings in the
suction tube groove.
IMPORTANT:
Avoid contaminating the oil or
food product by verifying that all
components of filter reservoir
assembly are completely dry
before reassembling.
WARNING: BURN HAZARD
HOT OIL SPILL OR SPLATTER
DO NOT REMOVE FILTER RESERVOIR WHEN IT CONTAINS HOT OIL
PROTECTIVE CLOTHING AND GLOVES MUST BE WORN
DURING THE FILTERING PROCESS
HOT OIL WILL CAUSE SEVERE BURNS ON CONTACT
Death or serious injury may result from contact with, or slipping and falling in, spilled oil.
WARNING
WARNING
WARNING: BURN HAZARD
DO NOT REMOVE FILTER RESERVOIR IF IT IS HOT.
WEAR INSULATED GLOVES OR ALLOW IT TO COOL.
Hot oil quickly heats reservoir. Touching hot reservoir
with bare hands can causing serious injury
Clean FILTER LEAF after each day’s filtration, or as needed to return
oil promptly to the kettle.
Open FRYER DOOR and slide the FILTER RESERVOIR forward to
remove it. Remove FILTER LEAF from reservoir.
Disassemble FILTER LEAF by separating the two side rails at the
joint with the straight pin. Clean all components in a sink with warm
water and mild detergent, or in a dishwasher.
Assemble SCREEN with the SEPARATOR installed between the
two screens. Verify that O-RING is in place on the suction tube on
BOTTOM SCREEN.
Slide screens into SIDE RAIL “B” (L-shaped pin). Hook SIDE RAIL
“A” over the pin on SIDERAIL “B” and work the screens into SIDE
RAIL “A” until straight pin on “A” is held by the “bump” on “B”.
Install FILTER LEAF in RESERVOIR with suction tube firmly into
filter drain hole.
Install filter reservoir into the fryer. Make sure the “O” ring closest
to end of SUCTION TUBE is firmly seated in SUCTION LINE
RECEPTACLE.
FILTER RAIL “B”
LOWER
FILTER SCREEN
SEPARATOR
UPPER
FILTER SCREEN
FILTER RAIL “A”
STRAIGHT
PIN
“L”-SHAPED
PIN
TOP VIEW
SIDE VIEW
FILTER LEAF ASSEMBLY