Filter
Top Products
18
Detaching and refitting the rails
The rails can be removed for cleaning. The oven must have
cooled down.
Detaching the rails
1.Lift up the front of the rail
2.and unhook it (figure A).
3.Then pull the whole rail forward
4.and remove it (Fig. B).
Clean the rails with cleaning agent and a sponge. For stubborn
deposits of dirt, use a brush.
Refitting the rails
1.First insert the rail into the rear socket, press it to the back
slightly (figure A),
2.and then hook it into the front socket (figure B).
The rails only fit on the right or the left side. Ensure that, as
shown in figure B, levels 1 and 2 are below and levels 3, 4 and
5 are above. The pull-out rail must be pulled out forwards.
Detaching and attaching the oven door
For cleaning purposes and to remove the door panels, you can
detach the oven door.
The oven door hinges each have a locking lever. When the
locking levers are closed (figure A), the oven door is secured in
place. It cannot be detached. When the locking levers are open
in order to detach the oven door (Fig. B), the hinges are locked.
They cannot snap shut.
: Risk of injury!
Whenever the hinges are not locked, they snap shut with great
force. Ensure that the locking levers are always fully closed or,
when detaching the oven door, fully open.
Detaching the door
1.Open the oven door fully.
2.Fold up the two locking levers on the left and right (figure A).
3.Close the oven door as far as the limit stop. With both hands,
grip the door on the left and right-hand sides. Close the door
a little further and pull it out (figure B).
Attaching the door
Reattach the oven door in the reverse sequence to removal.
1.When attaching the oven door, ensure that both hinges are
inserted straight into the opening (figure A).
2.The notch on the hinge must engage on both sides (figure B).
3.Fold back both locking levers (figure C). Close the oven
door.
: Risk of injury!
If the oven door falls out accidentally or a hinge snaps shut, do
not reach into the hinge. Call the aftersales service.
Accessories Hot soapy water:
Soak and clean with a dish cloth or
brush.
Area Cleaning agents
%
$
%
$
%
$
%
$
%
$
&