Filter
Top Products
20
7.Put the cover back in place and screw it on.
8.Attach the oven door.
Do not use the oven again until the panels have been
correctly installed.
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Malfunction table
If a dish does not turn out exactly as you wanted, refer to the
Tested for you in our cooking studio section, where you will
find plenty of cooking tips and tricks.
: Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Error messages with E
If an error message with E is shown in the display, press the
0 button. This cancels the error message. You may then have
to reset the time. If the error is shown again, call the after-sales
service.
You can take remedial action yourself if the following error
messages are displayed.
Replacing the bulb in the oven ceiling light
If the bulb in the oven light fails, it must be replaced. Heat-
resistant, 25 watt, 230 V halogen bulbs are available from the
after-sales service or specialist retailers. When handling the
halogen bulb, use a dry cloth. This will increase the service life
of the bulb. Only use these bulbs.
: Risk of electric shock!
Switch off the circuit breaker in the fuse box.
1.Place a tea towel in the oven when it is cold to prevent
damage.
2.Remove the glass cover. To do this, press the metal tabs to
the side with your thumb (Fig. A).
3.Pull out the bulb (do not turn it ) (Fig. B). Insert the new bulb,
making sure that the pins are in the correct position. Push the
bulb in firmly.
4.Refit the glass cover. When doing this, insert it on one side
and press firmly on the other side. The glass cover will click
into place.
5.Remove the tea towel and switch on the circuit breaker.
Problem Possible cause Note/remedy
The appliance does not work. Faulty circuit breaker Look in the fuse box and check that the circuit
breaker is in working order.
The text "Time 00:00" appears in the dis-
play. The time is not the current time.
Power cut
Reset the current time and press the
0 button.
The oven door cannot be opened. The text
"Time 00:00" is shown in the display. The
time displayed is not the current time.
Power cut during self-cleaning.
Set the current time and press the
0 button. Wait
until the cooking compartment has cooled down.
The
H symbol disappears. You can now open the
oven door.
The oven does not heat up or the type of
heating selected cannot be set.
Type of heating not recognised Make the settings again.
The oven does not heat up. The text
“Demo" is displayed.
The oven is in demo mode. Switch off the circuit breaker in the fuse box and
then switch back on after approx. 20 seconds. In
the next 2 minutes hold the
D button down for
four seconds until the text "Demo" disappears.
"Automatic switch-off" appears in the dis-
play.
Automatic switch-off has been
activated. The oven switches off.
Press any button. The text disappears. You can
make settings again.
Error message Possible cause Note/remedy
E011 A button was pressed for too long
or has jammed.
Press all buttons individually. Check that the but-
tons are clean. If the error message remains,
please contact the after-sales service.
E115 The temperature in the cooking
compartment is too high.
The oven door locks. Wait until the cooking com-
partment has cooled down. Clear the error mes-
sage with the
0 button.
%
$