Bosch Appliances HDS7052U Range User Manual


 
Getting Started
English 10
The locating pins on the outside edges of the cooktop fit into notches on the bot-
tom of the grates.
Burner grates should rest flat on the cooktop. When properly positioned, the
grates will be level and will not move back and forth.
Electronic Ignitor The cooktop uses electronic ignitors to light the burners, There is no pilot light.
Each burner has its own ignitor. For proper operation, keep the ignitor clean and
dry. It is necessary to clean these when there is a boilover or when the burner
does not light even though the ignitor clicks.
CAUTION:
All ignitors spark when any single burner is turned on. Do not touch
any of the burners when the cooktop is in use.
High Power Burner The high power burner is the largest burner. It is the most powerful burner on the
cooktop. It retains heat longer than normal burner caps and, at low settings, pro-
hibits the flame from touching the cookware. This results in a gentle, more pre-
dictable heat. Use the low settings on this burner to simmer large amounts of
sauces or soups. Use the high settings to quickly bring large amounts of water to
a boil.
Precision Burner The precision burner is the smallest burner on the cooktop. It is well suited for
gentle cooking of small amounts of food. Use the burner to melt butter or choco-
late or to prepare delicate sauces.
Oven Racks Depending on model, the range is equipped with one of the following combina-
tions:
Two flat racks and one full extension rack
Two flat racks and one half rack
Flat Oven Racks The racks are designed with a stop so they will stop before coming completely
out of the oven and not tilt.
CAUTION:
To avoid burns, place oven racks in desired positions before turning
oven on. Always use oven mitts when the oven is warm. If a rack
must be moved while the oven is hot, do not let oven mitts contact
hot elements.
Inserting Racks Into Oven
1. Grasp rack firmly on both sides.
2. Tilt rack up to allow stop into rack guide.
Figure 7: Grates for Slide-in Models - Locating Pins