Filter
Top Products
13
The dough hook should be used for all
heavier substances such as cookie doughs,
yeast doughs, pastry doughs and other
heavy doughs.The dough hook should
always be used when adding nuts,
chocolate chips, dried fruits, hard butter or
other fats, hardened brown sugar, etc. to a
mixture.
Use of mixing bowl with twin beating whisks
Before beginning to attach this or any other
attachment, make sure that the power unit
is on a smooth, clean, suitable surface and
switched to off position, “O/Off,” and that
you have removed the motor drive cover.
1. Before using the mixing bowl and twin
beating whisk assembly for the first
time, it is recommended that the bowl,
anti-splash cover, filling funnel cap and
twin beating whisk assembly be
washed. All components of the mixing
bowl and the twin beating whisk
assembly are dishwasher safe, except
the whisk holder.
The whisks may be removed from the
whisk holder as shown in figure 9a, and
washed in the dishwasher along with
the mixing bowl and other components.
The whisk holder should be washed in
warm soapy water. After washing, rinse
well and dry the whisk holder before
reattaching the whisks as shown in
figure 9b.
The driveshaft should also be removed
from the mixing bowl for cleaning, if it
has not already been done. See
previous section, covering mixing bowl
and dough hook, for instructions on how
to remove driveshaft.
2. If you have not already done so, remove
the motor drive cover and place the
mixing bowl on the mono drive of the
power unit and turn the bowl counter-
clockwise with a slight downward
pressure until bowl is firmly seated on
the mono drive coupling, see figure 4.
CAUTION
Failure to make sure that the bowl is
properly seated on the mono drive coupling
before the power unit is turned on can result
in damage to the bowl and/or coupling.
3. Place and engage the twin beating
whisk assembly on the driveshaft of the
mixing bowl as shown in figure 10a.
Figure 10.
4. Place the anti-splash cover on the bowl
so that the tabs on the bowl fit into the
recesses in the cover, and turn the anti-
splash cover counterclockwise to
fasten the bowl cover to the bowl.
See figure 10b.
The anti-splash cover has an integral filling
funnel with a cap. The cap may be removed
a. b.
Figure 9.
a. b.