Filter
Top Products
11
Figure 5.
5a. Cover w/dual feeding tubes
5b. Cover w/integral feeding tube
5c. Pusher/measuring cup
5d. Multifunction blade w/protective cover
5e. Dough hook
5f. Whipping whisk
5g. Fine grating disc
5h. Reversible slicing disc
5i. Reversible coarse grating disc
5j. Dough hook
5k. Whipping whisk
3. Engage the multifunction blade on the
dual drive of the power unit by placing
it over the center column, as shown in
figure 6a. Once in place, check to make
sure the multifunction blade has
engaged the dual drive by turning the
multifunction blade while pushing down
until it stops.
4. Next place the mixing bowl cover on
the bowl. Make sure arrows on cover
and bowl are aligned, so that tabs on
bowl fit into channels in cover and then
turn cover clockwise until tab on cover
enters cover interlock and turn until tab
clicks into place, figure 6b.
Figure 6.
The cover should be in place whenever
the power unit is in operation. The cover
serves to prevent accidental contact
with the moving blade. Also, the power
unit will not operate unless the tab on
the cover is in place and has engaged
the safety cover interlock.
Placing into Operation w/Multifunction
Blade
Make sure that the power unit is on a
smooth, clean, suitable work surface and
switched to the Off position, “O/Off.” Pull
the electrical cord out to the necessary
length and plug into a convenient outlet.
The mixing bowl with multifunction blade is
now ready for operation. The multifunction
blade should only be used using the
momentary contact position ”M” to prevent
over processing of food.
Sample recipes may be found in the recipe
section, at the back of this manual.