Filter
Top Products
21
place the cover, with pusher on the bowl
and turn clockwise until tab on cover
enters cover interlock and turn until tab
clicks into place, figure 15b.
Placing into Operation with Juice
Extractor
Make sure that the power unit is on a
smooth, clean, suitable work surface and
switched to the Off position, “O/Off.” Pull
the electrical cord out to the necessary
length and plug into a convenient outlet.
The mixing bowl with juice extractor is now
ready for operation.
Figure 15.
Juice Extractor tips:
Wash fruit and cut to fit into feeding funnel,
as required. Set the rotary switch to speed
3 and feed fruit through feeding tube. Use
pusher to feed in fruit, using light pressure.
Be sure to check level of juice in bowl and
empty juice into a suitable container before
level of juice reaches level of bottom of
strainer basket. Also watch strainer for pulp
buildup and, if necessary, stop the power
unit and remove pulp. See Removing
Contents, below.
Removing Contents
Before beginning to remove the contents
from the bowl or pulp from the strainer, make
sure that the power unit has been turned to
the Off position, “O/Off.” Remove the cover
of the juice extractor from the bowl by
turning the cover counterclockwise while
lifting. Then remove the grater/strainer.
Empty pulp from the strainer, as required.
If bowl needs to be emptied, pour juice into
a suitable container.
Care and Cleaning of Mixing Bowl with
Juice Extractor
The bowl and juice extractor are dishwasher
safe. Do not use scouring cleaners on the
bowl or juice extractor.
With the power unit turned Off and
unplugged, it should be cleaned only with
a clean, damp cloth. Then wipe off the safety
motor drive cover and reinstall on the power
unit, if necessary. Never use coarse or
caustic cleaning products to clean the
power unit. Never immerse the power unit
in water.
It is recommended that, after cleaning, the
mixing bowl and its cover be stored on the
food processor. In this way, if you wish at
some later time to use the blender, the
mixing bowl and its cover will already be in
place.