Filter
Top Products
9
6. Operate unit with rotary switch.
Once the attachment is in place, the
speed of its moving components can
be controlled through the use of the
rotary switch at the front of the power
unit. See figure 2. The rotary switch
has six or four positions, depending
on the model you have:
All MCM models have the following:
a. “M,” a momentary “pulse” position
that provides full speed and power
for the time it is held in position.
b. “O/Off,” the off position.
The MCM 5000 and 5100 have 2 speeds
c. Two speeds labeled 1 and 2.
Speed 1 is the lowest speed.
The MCM 5200 has 4 speeds:
d. Four speeds labeled 1, 2, 3 and 4.
Speed 1 is the lowest speed. The
speed increases with each
succeeding step up to the highest
speed, speed 4.
All models of the Bosch Food
Processor incorporate a built-in safety
cutout switch to protect the motor
against overheating. If the safety
becomes activated, the power unit will
stop. If power unit should stop even
though there is power to the unit see
TROUBLESHOOTING at the back of
this manual .
7. Turn power unit off.
When your work with the attachment
is completed or the capacity of the
batch-feed attachment has been
reached, turn the power unit to the Off
position, “O/Off,” and unplug.
8. Remove the attachment.
Remove the attachment from the
power unit, per instructions for the
specific attachment being used.
9. Continue use.
If the attachment was of the batch-feed
type and you wish to continue using
the attachment, empty the bowl or jar
of the attachment per its specific
instructions and reinstall the
attachment as before. Repeat steps
5 through 8 as often as necessary to
complete work.
10. Work completed,
remove attachment.
If the attachment is of the continuous
feed type or is the batch type and you
have completed the work you wished
to perform with the attachment,
remove the attachment from the power
unit per the instructions for the specific
attachment being used.
11. Place contents (batch-feed type).
If the attachment is the batch feed
type, disassemble per the specific
attachment’s instructions and place
the contents in a suitable container.
12. Care and cleaning.
Once you have completed working
with the Bosch Food Processor, the
next step is to disassemble and clean
the attachments. If you wish to use
another attachment, please return to
step 3, above.
Power unit
With the power unit turned Off and
unplugged, it should be cleaned only with
a clean, damp cloth. Then wipe off the safety
motor drive cover and reinstall on the power
unit, if necessary. Never use coarse or
caustic cleaning products to clean the
power unit. Never immerse the power unit
in water.
The power unit may be left on the counter
or stored for future use. If the unit will be
stored, store the cord and lift the power unit
and place in your chosen storage area.