Filter
Top Products
13
OPERATING YOUR BREVILLE KINETIX
®
AERO
DISASSEMBLING YOUR
BLENDER FOR CLEANING,
CARE AND STORAGE
1. Always ensure the Blender is off by
turning the dial to the OFF position.
Then switch off at the power outlet and
unplug the power cord.
2. Remove the blender jug from the motor
base by grasping the handle and lifting
the jug in an upward direction.
3. To remove the blade assembly for
cleaning, hold the jug up and remove
the collar from the base by turning it
anti-clockwise.
4. To remove the blades from the jug
apply pressure on the underside of the
blades. They should pop up inside the
blender jug.
MOTOR OVERLOAD
PROTECTION
• Your blender is equipped with overload
protection.
• If your blender is overloaded the motor
will stop and the “overload protection”
light will flash, next to the ice crush
button.
• Please do not attempt to use the blender
while the “overload protection” light is
flashing.
• Once the warning light stops flashing
(this could take up to 30 minutes) the
blender has cooled sufficiently and is
ready to use again. Reselect the desired
speed or function. If you have turned
the blender off you will need to switch
it back on, wait for the flashing light to
stop then reselect the desired speed or
function.
• We recommend removing a portion of
the mixture, cutting food into smaller
pieces of even sizing and / or processing
a smaller amount per batch.
REASSEMBLING YOUR BLENDER
JUG AFTER CLEANING
1. Ensure parts are clean and
completely dry.
2. Turn the blender jug upside down on the
bench. Place the blade assembly collar
onto the blade assembly and turn in a
clockwise direction until tight.
3. Place the inner measurement cup into
the lid and turn until firmly locked into
position.
WARNING
Never place anything other than food
and liquids in the blender whilst the
motor is running.
WARNING
Be careful when handling the blending
blades as they are sharp. Mishandling
of the blades may cause injury.