Filter
Top Products
12
OPERATING YOUR BREVILLE HEMISPHERE™ CONTROL BLENDER
Step 4
Plug power cord into a 110/120V power
outlet and turn on.
Step 5
Press the
button on the far left of
the control panel to turn the blender on.
The
button will illuminate and
flash. The LCD timer screen will illuminate
with ‘00’ displayed.
NOTE
Flashing light indicates ready to operate.
Avoid any contact with moveable parts
while in operation.
NOTE
Do not fill the blender jug above the
‘MAX’ line. When the blender jug is filled
at or near the ‘MAX’ line place one hand
on the blender lid to avoid displacement
of the lid during operation.
Step 6
Select the required speed (1 to 5) by pressing
the corresponding speed button. The blender
will start to operate and the selected speed
button will illuminate. The
button
will illuminate and cease to flash.
The ‘Stop’ button will illuminate and flash.
The LCD timer screen will start counting up
in one second increments until 60 seconds
is reached.
NOTE
Operate the blender only for the
appropriate amount of time required –
do not over blend.
Step 7
When 60 seconds is reached, the blender
will automatically stop blending and the
selected speed button and ‘Stop’ button
illumination will go out. The
button
will illuminate and flash. After a few seconds
the LCD timer screen will revert to ‘00’.
NOTE
• The Breville Hemisphere
™
Control
Blender will automatically stop
blending after 60 seconds
(1 minute). This is a safety feature
and restricts wear on the motor.
• To stop blending at any time, press
the ‘Stop’ button or the selected
speed button. The
button
can also be pressed, but this will
also turn the appliance off and all
illuminations will go out.
• The speed can be changed at any
time during the blending process.
Each time a new speed is selected
its button will illuminate and the
previous speed button illumination
will go out. The number of seconds
on the LCD timer screen will
continue to count upwards to
60 seconds unless interrupted.
Step 8
The Breville Hemisphere
™
Control Blender
features two additional functions, ‘ICE
CRUSH’ and ‘SMOOTHIE’. These two pre-
programmed cycles automatically adjust
the blending time and speeds to optimise
blending results. Select the required
function by pressing the corresponding
function button. The blender will start to
operate and the selected function button
will illuminate. The
button will
illuminate and stop flashing. The ‘Stop’
button will illuminate and flash. The LCD
timer screen will start counting down in one
second increments until ‘00’ is displayed.
BBL605XL_IB_A11_FA.indd 12 9/08/11 10:20 AM