Filter
Top Products
Burr brush
Tamp removal
magnet
Grind outlet
brush
34 35
CARE & CLEANING
CLEANING CYCLE
• CLEAN ME! will be displayed on
the LCD to indicate when a cleaning
cycle is required (approx. 200 shots).
The cleaning cycle cleans the shower
screen and back-flushes the group head.
• Insert the supplied grey silicone
cleaning disc, followed by 1 cleaning
tablet into the filter basket.
• Lock the portafilter into the group head.
• Ensure the water tank is filled with cold
water and the drip tray is empty.
• Press the MENU button and rotate
SELECT dial until 'CLEAN CYCLE' and
'PUSH' are displayed on the LCD.
SELECTSELECTSELECT
TEMP TEXTURETEMP TEXTURETEMP TEXTURE
MENU
EXIT
• Press the SELECT dial to start the
cleaning cycle.
• The LCD will display a countdown timer
showing remaining time for the cleaning
cycle in seconds.
• When the cleaning cycle has finished,
remove the portafilter and ensure the
tablet has completely dissolved. If the
tablet has not dissolved, repeat these
steps, without inserting a new tablet.
• Rinse the filter basket and portafilter
thoroughly before use.
• Extract an espresso to "season" the
machine and purge the system of
any remaining cleaner.
INSTALLING THE WATER FILTER
• Discard the used water filter. Soak a new
filter in a cup of water for 5 minutes,
then rinse under cold running water.
• Wash the filter holder with cold water,
taking specific care to rinse the stainless
steel mesh.
• Insert the filter into the two parts of the
filter holder.
• To install the assembled filter holder
into the water tank, align the base of the
filter holder with the adapter inside the
water tank. Push down to lock into place.
• Fill the water tank with cold water before
sliding back into position at the back of
the machine and locking into place.
NOTE
Visit www.breville.com.au or call Breville
Customer Service Centre to purchase
water filters.
13
Replace & lock
hopper
Remove beans Run grinder until empty Unlock & remove
hopper
Remove upper
burr
Unlock hopper
1 2 3 4 5
6
Clean lower
burr with
burr brush
Remove tamping
fan with tamp
removal magnet
Clean upper
burr with
burr brush
7 88 9
Clean grind
outlet with grind
outlet brush
10
Replace tamping
fan by hand
11
Push upper
burr firmly into
position
12
Lock upper burr
14
Insert hopper
15
Lock hopper
CLEANING CONICAL BURRS
Regular cleaning helps the burrs achieve consistent grinding results which is especially
important when grinding for espresso.
CARE & CLEANING