Filter
Top Products
40 41
CARE & CLEANING
g) Empty drip tray and reinsert into
position. Use caution as the drip tray
may be hot due to the water and steam
from the boilers.
h) Press SELECT dial to proceed to next
step.
Step 5 – Fill Boilers
During Step 5 procedure, the grind LCD
will display '05'.
a) 5 minute timer will begin. During this
time, water may flow through the group
head. Wait for countdown timer to
reach 0:00. This allows any remaining
solution to be removed from system.
Step 6 – Flush Boilers
During Step 6 procedure, the grind LCD will
display '06' and the main LCD will display
'PUSH'.
a) Empty and rinse water tank. Assemble
new water filter into tank.
b) Fill water tank with cold water to MAX
line. Replace and lock water tank back
into position at the back of the machine.
c) Ensure drip tray is empty and fully
inserted into position.
d) Place a cloth over the drip tray to stop
steam escaping.
e) Use a flat-head screwdriver to rotate the
right screw counter-clockwise until the
valve is fully open. As the valve opens,
steam may be released.
CAUTION
HOT WATER & STEAM
f) Next, repeat the above process on the
left screw. As the valve is opened, water
may begin flowing into the drip tray.
g) Allow valves to remain open until no
more water or steam escapes.
h) Close both valves by rotating screws
clock-wise until seated. Do not
overtighten screws to avoid damaging
the valves. Replace the grey silicone
cover over the valves.
i) Empty drip tray and reinsert into
position. Use caution as the drip tray
may be hot due to the water and steam
from the boilers.
j) Press SELECT dial to complete descale
procedure. Machine will heat up and is
ready to use once operating temperature
(STANDBY mode) is reached.