Filter
Top Products
5
INITIAL SET-UP
CAUTION - The dispenser must be disconnected from the power source throughout the initial set-up, except
when specified in the instructions.
1. Connect the dispenser to the power source and turn on the water supply.
2. The “HEATER” LED will glow for approximately five seconds. During this time, the electronic circuitry will
check for a full tank of water.
3. If the tank is not full of water, the refill circuit will energize, indicated by the “REFILL” LED glowing. Water
will automatically flow into the tank to the proper level and then shut off.
4. When the tank is full of water, the heater circuit will energize, indicated by the “HEATER” LED glowing
intermittently until the proper temperature is achieved. A completely cold tank will take approximately
twenty minutes for the water to heat.
5. The “READY” LED will glow when the proper water temperature is achieved.
NOTE - Stop dispensing if the “READY” LED is off. Dispense only when the ”READY” LED glows.
DRAINING THE DISPENSER
CAUTION - The dispenser must be disconnected from the power source throughout these steps.
1. Disconnect the dispenser from the power source.
2. Shut-off and disconnect the incoming water supply
3. Remove the small screws from the sides and front of the top panel.
4. Gently remove one of the grommets from the tank lid.
5. Insert a tube to the bottom of the tank and syphon ALL of the water out.
NOTE - The dispenser must be refilled using the INITIAL SET-UP steps before reconnecting to the power source.
CLEANING
The use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all
surfaces on Bunn-O-Matic equipment.
10889 091599