Filter
Top Products
Page 25
PROGRAMMING THE BREWER (cont.)
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
BREW
A
BREW
B
BREW
C
BREW
A
BREW
B
BREW
C
BREW
A
BREW
B
BREW
C
EXIT TO
NEXT FUNCTION
SCREEN
REVIEW RECIPES?
NO YES
TEA 1
MODIFY SHOW NEXT
(COFFEE NAME)
MODIFY SHOW NEXT
SCROLLS THRU
TEA 1, TEA 2, TEA 3,
HOT TEA, ICED COFFEE
and NO-NAME
COFFEE RECIPES
SET UP BREW VOLUMES, PULSE BREW
TIMES, AND DRIP OUT TIME
P2857
36748 101505
4. To show (view) this information, press and release
SHOW. The display will scroll through all of the
brew settings for that recipe. This display will then
return to CARD CONTAINS RECIPE FOR then will
change to (COFFEE NAME) SHOW QUIT SAVE.
5. If all brew settings are correct, press
SAVE. The
display will read (COFFEE NAME) SETUP COM-
PLETE. All brew settings for that name are now
stored in the brewer’s memory.
6. If the brewing information is not correct, or it is
desired to exit the setup before the settings are
loaded into the brewer’s memory, press QUIT. The
display will read (COFFEE NAME) NOT SAVED. The
display will then return to the MAIN SCREEN.
SET NEW RECIPE
If not using a Smart Funnel and/or a G9-2T DBC or
MGH Grinder and/or a Recipe Card
It is possible to operate the brewer without using a
Smart Funnel and/or G9-2T DBC or MHG Grinder. If
a standard funnel or if a non-DBC grinder is used the
brewer will automatically select the recipe assigned to
that brew button. This means that no name was read
from the funnel’s handle.
For instructions on programming the NO-NAME COF-
FEE settings, refer to the REVIEW RECIPES function
on page 34. The same steps are followed for setting
the NO-NAME COFFEE recipe as those that are used
to modify a recipe. Note that when the display reads
NO-NAME COFFEE, that is when MODIFY should be
pressed in order to set the parameters.
NOTE: Before beginning setup, insert a funnel into the
funnel rails and place a server or dispenser beneath
the brew funnel.