Filter
Top Products
Page 7
TWF-EZ ADJUSTMENTS & OPTIONAL SETTINGS
Adjusting Brew Volumes
BREW VOLUME SET-UP: Use the following steps
when setting up the brewer for the first time.
1. Place an empty funnel in the funnel rails and an empty
decanter (when switch is in "COFFEE" position) or 3-
gallon dispenser (when switch is in the "TEA" posi-
tion) beneath the funnel.
2. Place the "TEA/OFF/COFFEE" switch in the "TEA" or
"COFFEE" position.
P1864
P1901
29466 082200
3. Press and hold the brew start switch until you
hear the brew solenoid click on-and-off three
times (approximately 5 seconds). Release the
switch immediately. Failure to release the switch
within 2 seconds of the third click causes the
volume setting to be aborted and the previous
volume setting will remain in memory.
4. Allow the cycle to continue until the desired
amount of water is dispensed and then place
the "TEA/OFF/COFFEE" switch in the "OFF" po-
sition.
The brewer is now set to dispense this amount of
water for each subsequent brew cycle.
To increase the amount of water for each brew
cycle place an empty funnel in the funnel rails and
an empty decanter (when switch is in the "COF-
FEE" position) or empty 3-gallon dispenser (when
switch is in the "TEA" position) beneath the funnel.
Place the "TEA/OFF/COFFEE" switch in the "TEA" or
"COFFEE" position. Press and hold the "START"
switch until you hear the solenoid click on-and-off
three times (approximately 5 seconds), then re-
lease the "START" switch immediately. Failure to
release the switch within 2 seconds of the third
click causes the volume setting to be aborted and
the previous volume setting will remain in memory.
Momentarily press and release the "START" switch
once for each 3.2 ounces (approximate) of water
to be added to the prior setting and allow the brew
cycle to finish.
To decrease the amount of water for each brew
cycle place an empty funnel in the funnel rails and
an empty decanter (when switch is in the "COF-
FEE" position) or empty 3-gallon dispenser (when
switch is in the "TEA" position) beneath the fun-
nel. Place the "TEA/OFF/COFFEE" switch in the "TEA"
or "COFFEE" position. Momentarily press and re-
lease the "START" switch once for each 3.2 ounces
(approximate) of water to be removed from the
existing setting. Press and hold the "START" switch
until you hear the solenoid click on-and-off three
times (approximately 5 seconds), then release the
"START" switch immediately (failure to release the
switch within 2 seconds of the third click causes
the volume setting to be aborted and the previous
volume setting will remain in memory) and allow
the cycle to finish.