Filter
Top Products
Page 10
PROGRAMMING WITH AD CARD
Using an AD CARD to load ADS:
The information is loaded into the brewer’s memory
by holding the chip area up to the brewer’s SENSING
COIL.
NOTE: Instructions to program the brewer are printed
on the AD CARD.
Procedure to program the AD:
1. Remove the funnel(s) if present.
2. Position the RECIPE CARD vertically, so that the
top end of the CHIP is beneath the (Left on Twins)
SENSING COIL (located on the underneath side of
the front display panel).
3. After a short pause the display will read CARD
CONTAIN ADS/SHOW-QUIT-SAVE.
4. To show (view) this information, select "SHOW".
The display will scroll through all of the ad on that
chip. The display will then return to CARD CONTAIN
ADS/SHOW-QUIT-SAVE.
5. If message is correct, press SAVE. The display will
read AD MESSSAGE SETUP COMPLETE. The ad is
now stored in the brewer’s memory.
6. If the ad is not correct, or it is desired to exit the
setup before the ad is loaded into the brewer’s
memory, press QUIT. The display will then return
to the MAIN SCREEN.
READY TO BREW
WATER TEMP XXX°
CARD CONTAIN ADS
SHOW QUIT SAVE
AD MESSAGE
SETUP COMPLETE
READY TO BREW
WATER TEMP 200°
POSITION CARD UNDER
SENSOR COIL
SCROLLS THROUGH
COMPLETE MESSAGE
NOTE: ENABLE ADS must be
turned on in LEVEL 2 in order
for the newly programmed ad
message to be displayed.
41581.2 091609
NOT AVAILABLE ON ITB