Filter
Top Products
8
Installation / Assembly
2009 Pizza Cart
LTR20091039, Rev. A
www.calspas.com
Natural Gas
Warning: All pizza ovens use LP unless they are converted to natural
gas. Do not connect natural gas to an unconverted pizza oven!
Requirements
Always check the rating plate to make sure the gas supply you are
hooking up to is the gas type the pizza oven is manufactured for.
IMPORTANT: Never connect the pizza oven to an unregulated gas sup-
ply.
The installation of this appliance must conform with local codes or,
in the absence of local codes, to the national fuel gas code, ANSI
Z223.1a-1998. Installation in Canada must be in accordance with the
standard CAN/CGA-B149.2, Propane Installation Code.
A licensed contractor or local gas company representative must per-
form all natural gas connections.
Ensure that the service supplying the pizza oven is tted with a shut
off valve conveniently positioned near the pizza oven and giving ease
of access.
The pizza oven and its individual shutoff valve must be disconnected
from the gas supply piping system during any pressure testing of that
system at test pressure in excess of 0.5 psi (3.5 kPa).
Your pizza oven for use with natural gas comes equipped with its own
regulator that MUST NOT be removed. If this regulator needs to be re-
placed, use only the type specied by Cal Flame™ for this appliance.
Connection
Remove the rear panel from the pizza oven to gain access to the 1.
regulator and gas connection point.
Connect a suitable ex connector to the regulator.2.
Check the controls to ensure all control valves are in the full OFF 3.
position.
Turn on the main gas supply and check all connections for leaks 4.
using soapy water as described in the leak testing procedure sec-
tion.
Warning: If you see bubbles in the soapy solution at any of the connec-
tions, turn off the gas supply and tighten the connection. If tightening
the connection does not seal the leak, it may be necessary to replace
the ex hose.