Filter
Top Products
23. CLEARYL WATER FILTER CARTRIDGE
The machine comes with one Clearyl Water Filter Cartridge. The
Clearyl cartridge
• Reduces the water hardness up to 75%.
• Removes (if present) up to 85% chlorine, up to 90% lead, up
to 95% copper and up to 67% aluminum.
• Cleans the water through an upward current principle (Fig. 9)
just before the brewing cycle starts, ensuring freshly filtered
water every time you make coffee.
• Eliminates decalcifying except when using very hard water
(25 grains or higher), see chapter 24. In this case we recom-
mended to decalcify the Z5 once or twice a year.
• To reorder cartridges, see chapter 34.
23a. INSTALLING & ACTIVATING THE CLEARYL WATER
CARTRIDGE
Installing:
Important:
Never install the cartridge before or during
"Preparing Machine For The First Time" (chapter 6).
• Remove cartridge from its bag and rinse cartridge under water.
• Add the extension rod to the cartridge (Fig.8).
• Remove the water tank, make sure it is empty.
• Pull up the cartridge holder and insert the cartridge with its
tapered end down (Fig. 10). Make sure it fits securely over the
white mesh piece inside the water container. Push down
gently (Fig. 11).
• Close the cartridge holder. Make sure the holder snaps into
place.
• Fill the water tank with fresh cold water and replace.
Activating:
You must activate the cartridge otherwise the Z5 cannot monitor
it properly and assumes that the machine is still in decalcifying
mode.
COFFEE READY
• Push the Rotary Dial until you hear a beep.
FILTER NO
• Push the Rotary Dial again, to enter the FILTER program.
• Turn the Rotary Dial until the display shows FILTER YES and
push the Rotary Dial to confirm. The display shows INSERT
FILTER PRESS BUTTON
and the Rinse Button illuminates.
• Place a 20 oz. container under the Auto Cappuccino System.
• Push and hold the Rinse Button until the display shows
FILTER RINS. For the next 90 seconds the Z5 will push
water through the cartridge and out through the milk nozzle.
Initially, the water may have a slight discoloration. The program
will stop automatically. The display shows UNIT IS HEATING
and then COFFEE READY.
Please note: If your container is not large enough, you can
interrupt the activation cycle by simply pressing any beverage
button. The display shows PRESS BUTTON and the Rinse
Button is still illuminated. Replace the empty container and
continue the filter activation by pressing the Rinse Button.
Please note: As long as the filter is activated, the water
hardness setting is automatically turned off.
23b. REPLACING THE CLEARYL WATER CARTRIDGE
The filter is monitored automatically. After approx. 75 liters of
water (~2,500 oz.) the display shows
COFFEE READY and
FILTER-CHANGE. The Rinse Button will light up.
20.