Filter
Top Products
7
2 / INSTALLING YOUR DISHWASHER
• CONNECTING TO THE WATER SUPPLY
Fig. 07
Danger :
The symbol indicates that the hose
is fitted with an electrical device for cutting
off the water supply (depending on the
model). Do not leave this hose in water and
do not cut it.
NB:
Any connection to a water conduit
necessarily involves the risk of a leak occur-
ring, whatever the precautions taken.
Therefore, always close the water tap when
you are not using your machine.
This dishwasher can be supplied with cold
water or hot water up to a maximum of 60°C.
When supplying with hot water, check that
your original hose allows such connection
(red marking on the hose). However, we
recommend that you connect to the cold
water supply. Your appliance is fitted with a
supply hose 1.50m long.
Connect the hose to a tap with a threaded
end, diameter 20/27 (3/4" BSP).
Check that the water pressure does not
exceed the values below:
Flow rate: 10 L/min (1 L/min minimum)
Pressure: 1 to 10 bars (0.1 - 1 MPa) (Fig. 07)
If the water pressure is too high, please fit a
pressure regulator. Your Water department
will advise you of the water pressure in your
region.
Warning :
If you use a self-piercing tap, check
that there is sufficient water flow.
Check that the hose seal is present and that
the connection is tight. (Fig. 05)
Do not re-use any previously used hoses for
making the connection.
Avoid any kinks or constrictions in the hose,
which could prevent the water from passing or
slow down its flow, particularly when building
in the appliance under the worktop. (Fig. 8).
If the appliance is connected to new pipes or
pipes that have not been used for a certain
length of time, let the water run for a few minu-
tes before connecting the water hose to avoid
and deposits of sand or rust that could block
the water hose’s filter.
00..11-- 11 MMPPaa
11--1100 bbaarr
1100LL//mmiinn
Fig. 08