Filter
Top Products
26 10005360
LHE Series Natural Vent Insert
Modification Instructions of
EP28-5 Series Fireplace
Upgrading to LHEC20 or LHER20
Natural Vent Insert
WARNING: You must turn off gas supply to
fireplace.
1. Remove the upper and lower trims.
2. Remove the doors and mesh firescreen, if installed.
3. Remove the bottom door rail. (Fig. 28)
4. Disconnect the gas supply from the control valve un
-
der the fireplace. Remove the two (2) screws located
at bottom rear of burner pan. Disconnect the primary
spill switch from the gas valve. Leave the primary
spill switch in its location, as it must be rewired to
complete the new burner assembly installation. Lift
the complete burner assembly up and out of unit to
clear support ledge. (Fig. 29) Remove the existing
fan assembly, if installed.
5. Remove the hood and inner baffle. (Fig. 30)
6. Install the LHEC20/LHER20 insert by pushing it all
the way back inside the shell. (Fig. 31) For complete
gas line and venting installation, refer to Pages 6
and 8.
FP1506
EP28-5
remove bottom door rail
6/17/04 djt
FP1506
Fig. 28 Remove the bottom door rail.
FP1507
EP28-5
remove old burner
6/17/04 djt
FP1507
Fig. 29 Remove the old burner assembly.
FP1508
EP28-5
remove inner baffle
and hood
6/17/04 djt
FP1508
Hood
Inner
Baffle
Fig. 30 Remove the decorative burner hood and inner baffle.
FP1523
insert in
EP28
6/04
LHEC20
or
LHER20
Insert
EP28-5
Series
Fireplace
FP1523
Fig. 31 Install insert by pushing it all the way inside the shell.