Filter
Top Products
To LOCK OUT others from changing the settings, read:
PARAMETERS, (*78) - Changing the Password.
To VERIFY ACCURACY of the entire system, read:
PRINTER OUTPUT and TROUBLESHOOTING sections.
To TRACK MATERIAL usage, read:
KEYPAD, VIEW DATA, and PARAMETERS, PRT Parameter.
To configure TWELVE software to look and act like FOUR software, See:
KEYPAD, STAR FUNCTIONS (*04) - Configuration to FOUR software.
READ the rest of the manual at your leisure to learn more about how
your AUTOWEIGH BLENDER works and what else it can do.
KEYSTROKE SEQUENCE for these or other SPECIAL FEATURES
With STOP END OF CYCLE switch DOWN,
Turn POWER ON. Wait 5 seconds, until display says ( x)
Press: * Display will say: (PASSWORD)
Press: 22222 Display will say: (P x)
This is the PROGRAM MODE
To alter a PARAMETER; press: PARA key
Press repeatedly until the parameter you want is displayed.
If you accidentally pass it, use the * key to back up.
With the proper parameter displayed, enter the NEW number.
Enter 5 digits; use leading zeros if necessary.
For correct entries, follow specific directions given in the
PARAMETER section.
Press: EXIT when correct parameter has been entered.
To make a (*XX) entry:
Be in the PROGRAM mode, the same as above.
Display will say (P x)
Press: * Display will say (INSTR --)
Enter the 2 digit code.
For correct entries, follow specific directions given in the
KEYPAD section, STAR FUNCTIONS.
Press: EXIT when correct information has been entered.
When finished, press EXIT again to exit the PROGRAM MODE.
Page 24