Filter
Top Products
Basic Setup HDC II Programming Guide
6730018 7 July, 2003
PROGRAMMING PROCEDURES
Basi c Se tup
GAIN ACCESS TO THE SUPERVISOR MODE
1. Press . The display shows: . You must enter the four-
digit supervisor code within 6 seconds to gain access.
NOTE
A new machine has a factory-set supervisor code of 0000.
When you have entered the right code, you will hear two beeps and see
in the display.
ENTER A NEW SUPERVISOR CODE
1. Follow the steps in "Gain Access To The Supervisor Mode", PAGE 7.
2. Press . The display shows . The X's represent the cur-
rent supervisor code. Use the number keys to enter a new code.
IMPORTANT
If you enter a new code, be sure to keep a written record of it.
There is no other way to access the SUPERVISOR mode.
3. CONTINUE.
ENTER A FREEVEND CODE
1. Follow the steps in "Gain Access To The Supervisor Mode", PAGE 7.
2. Press , then until the display shows . The X's
represent the current freevend code. Use the number keys to enter a new
code. If the code is anything other than "
", it must be entered after the
key lock is turned in order to enable free vends.
3. CONTINUE.