Filter
Top Products
HDC II Programming Guide Messages
July, 2003 48 6730018
SELECT A STANDBY MESSAGE
Messages
1. Press , then press until the display shows .
"XX" represents the current message number selected for the standby mes-
sage. Two dashes mean that the factory-set message is selected.
2. To select a message, just press the corresponding number (1 through 8). To
display the factory-set message, press 0.
3. The selected message (except the factory-set message) can be edited. To do
this, press and follow the procedure given in
EDIT CUSTOM MES-
SAGE, page 49.
4. CONTINUE.
SELECT AN OUT-OF-SERVICE MESSAGE
1. Press , then press until the display shows .
"XX" represents the current message number selected to display when the
machine is out-of-service. Two dashes mean that the factory-set message is
selected.
2. To select a message, just press the corresponding number (1 through 8). To
display the factory-set message, press 0.
3. The selected message (except the factory-set message) can be edited. To do
this, press and follow the procedure given in
EDIT CUSTOM MES-
SAGE, page 49.
4. CONTINUE.
SELECT A FREEVEND MESSAGE
1. Press , then press until the display shows . "XX"
represents the current message number selected for the message that dis-
plays when the machine is in the freevend mode. Two dashes mean that the
factory-set message is selected.
2. To select a message, just press the corresponding number (1 through 8). To
display the factory-set message, press 0.
3. The selected message (except the factory-set message) can be edited. To do
this, press and follow the procedure given in
EDIT CUSTOM MES-
SAGE, page 49
4. CONTINUE.