Filter
Top Products
Hot Drink Center Set-Up Manual
6530007 D-1
March, 2001
APPENDIX D. MODIFY CANISTER TO VEND 12 OZ.
CUPS
Proceed as follows:
2. Remove all cups, then remove the turret center and turret base assembly
from the canister.
3. Break off all 8 tabs on the bottom of the turret base as shown.
NOTE
You will no longer be able to vend smaller cups from this
canister! To return to vending smaller cups you must
replace the modified turret base with an original turret
base (part number 6233048) from National Vendors Parts
Department.
4. Replace the turret center and turret base in the canister and load cups.
5. Drop a cup. If it drops properly, you are finished with the procedure, if not,
continue with step
6.
6. Remove all cups, then remove the canister from the cup mechanism assem-
bly.
7. Remove the funnel, replace the canister, and reload cups.
8. Drop a cup. If it drops properly, you are finished with the procedure, if not,
continue with step
9.
9. Order a universal cup ring (part number 6333008) from National Vendors
Parts Department.