Filter
Top Products
10
Problem: I want to reset the coffee
programming.
Solution:
• See page 7 for instructions.
Problem: Manual/Steam
buttons flash.
Solution:
• The steam control dial is in the wrong
position. Turn it back to the "0" position
and power the machine off, and on again
to reset.
Problem: The control lights are not as
bright as they were.
Solution:
• The machine has an energy-saving
feature that dims the lights and power by
about 50% after 30 minutes of non-use.
Restore full power by pressing any
button.
Problem: Machine turned off.
Solution:
• The machine’s auto-off feature turns
the coffeemaker off after 60 minutes of
non-use.
Problem: Coffee is too hot.
Solution:
• Press the HOT
button and wait until
the light is steady.
Problem: Coffee is not hot enough.
Solution:
• Press the HOTTER SETTING
button and wait until the light is steady.
• If still not hot enough at hotter setting:
with no capsule in the brew head, use
the Manual
button to dispense a cup
of water to preheat, then make your
espresso as indicated on page 6.
Problem:
SHORT /LONG buttons
flash quickly; all buttons are
non-functional; or some buttons
are off.
Solution:
• Indicates the coffee boiler has short-
circuited or detects low temperature.
Recover the unit by unplugging it and let
the unit cool down for approximately 10
minutes.
Problem: Short
/Long /
Manual/Steam
buttons flash.
Solution:
• Refill the water reservoir or make sure it
is properly engaged on the base.
Problem: Machine shuts off (not related to
auto shutoff).
Solution:
• Brew head must be closed during coffee
brewing and milk frothing.