Filter
Top Products
8
8. If you do not need foam, but only steamed
milk, lower the steam nozzle further into
the milk to prevent excess foam from
forming. Move the pitcher in a circular
motion so wand is not steaming in
one place.
9. Stop the steam immediately by turning the
STEAM
control dial to the closed position
.
10. Remove the pitcher, immediately wipe the
steam nozzle and wand with a clean damp
cloth and purge a small amount of steam.
USING THE HOT WATER
FUNCTION
1. Place the cup or container under the
steam/hot water nozzle and activate the
hot water function
by turning the
steam and hot water control dial to the hot
water setting.
2. Once you have dispensed the required
amount of hot water into the cup or
container, stop the hot water by turning
the steam/hot water control dial to the O
position.
3. Remove the cup or container and swing
the steam/hot water wand over the drip
tray to catch any drips of water.
TEMPERATURE
CONTROLS
Hotter is the default setting. If Hot is
desired, press the
button and allow a few
seconds for the temperature to decrease.
The flashing light will turn steady when it has
reached temperature.
NOTE: When the machine shuts off, and is
turned back on, the last temperature setting
used will be illuminated.
Energy Saver Mode
After 30 minutes of non-use the espresso
machine will automatically switch to sleep
mode and all the control lights will be
dimmed by about 50%. When any button is
pressed, the espresso machine will return to
preheat mode and all the lights will flash.
The machine is ready to operate when all the
lights are steady again.
Auto-Off Mode
Following the 30-minute
Energy Saver cycle, if
there is an additional
30 minutes of non-use,
the espresso machine
will turn off. Press the power button to turn
on again.
CLEANING AND
MAINTENANCE
Cleaning External Parts
We recommend regular cleaning of the
espresso maker’s external components.
1. Never immerse the machine in water or
other liquids. The housing and external
parts may be cleaned with a soapy, damp,
non-abrasive cloth.
2. To remove the drip tray, simply slide it
toward you, keeping it level at all times in
order to prevent spills. The drip tray and
drip tray grate are dishwasher safe. Do
not clean drip tray with cleansers, steel
wool pads or other abrasive materials.
Cleaning the Water Reservoir
It is normal over time for discoloration,
spotting or staining to appear in the water
reservoir. Results will vary depending on the
mineral content of the bottled or filtered
water used but will not affect the operation
of the machine. However, be sure to clean
the water reservoir regularly to minimize
build-up.
Clean inside the water reservoir with a damp,
lint-free cloth as necessary.
Cleaning The Steam Wand
1. The steam wand should always be
cleaned after steaming milk. Remove the
stainless steel part and clean both
thoroughly.
2. Wipe the steam wand with a damp cloth,
then with the steam wand directed back
into the drip tray, press the STEAM
button and turn STEAM control dial. This