Filter
Top Products
8
Attach the self-rimming side panels included with the 11)
unit by snapping the ball studs on the front into the
back of the control panel and kick panel. The finished
side of each side panel faces out.
Fasten the top of each side panel to the control panel 12)
with two of the included #8 x 1/4” Torx screws (A).
Insert them through the holes created when the end
caps were removed in step 10 and tighten into place.
Finish fastening the side panels to the range using the 13)
existing screws (B) removed in step 9. Two screws will
be left over and may be discarded.
Replace the control panel end caps.14)
Adjust the Range Height
For stand alone configurations, raise the range until 1)
the top of the trim around the cooktop is at least
the same height as the countertop. For self-rimming
configurations, raise the
range until the bottom of
the trim surrounding the
cooktop is even with the
countertop. To adjust the
height, turn the foot on
the bottom of each leg as
shown below.
Use a level to make sure 2)
that the range does not
tilt front to back or side to
side. Readjust the legs as
necessary.
Self-Rimming Trim Installation (cont.)
Re-attach the backguard using the supplied #8 x 1/4” 8)
Torx screws. If there is a countertop overhang to the
rear of the range of 3/4” or greater, attach the rear
trim piece to the backguard as shown below during
re-installation. IMPORTANT: To ensure proper fit, do
not use the screws removed from the range in previous
steps. Use only the provided #8 x 1/4” Torx screws.
Remove and retain the screws (4 each side) from the 9)
factory installed side panels on the unit. Remove the
side panels.
Remove both control panel end cap screws and 10)
remove both end caps. The end cap screws are
accessed through holes on the under side of the trim
protruding from the front of the control panel.
Installation Instructions
up
down
Kick panel
A) #8 x 1/4” Torx screw included with range (2 places)
B) Existing screw removed in step 9 (6 places)
A
A
B
B
B
B
B
B
Control
panel
Ball
studs
Remove end cap,
both sides
Remove both
side panels
Rear trim
piece (optional)