Filter
Top Products
12
Installation Instructions
4. Check for leaks under the dishwasher and under
the sink. If any leaks are found, immediately push
the STOP button and disconnect power. If there
are leaks under the sink, check the water supply
and drain connections. Reconnect power and
restart the cycle. If the leak is elsewhere, and
a hose extension is installed, check for a loose
connection.
5. If the dishwasher functions normally, complete
the installation as instructed on the following
sections.
If the dishwasher fails to operate
properly:
• Verify that power is supplied to the dishwasher.
• Check all plumbing connections.
• Check for kinks in the water supply line and the
drain hose.
• Repeat the Wet Test Checklist.
• If the appliance still does not work, contact Dacor
Distinctive Service at (877) 337-3226. Do not
attempt to repair the appliance yourself. If you
need service, be sure to have the model and
serial numbers available when you call. See the
inside cover for location.
Dacor is not responsible for the cost of correcting
problems caused by a faulty installation.
Final Leveling
1. Check to make sure that adjacent drawers and
cupboards can be opened when the dishwasher
door is open. Reposition the dishwasher if
necessary.
2. Check that there is a 1/8” (3.0 mm) space
between the top of the dishwasher door and the
underside of the cabinet.
3. If necessary adjust the front leveling legs until the
dishwasher is the correct height. Both front legs
must contact the floor solidly.
4. Check to make sure the unit is level side to
side and front to back. Also check to make sure
both front legs are contacting the floor securely.
Readjust the leveling legs as necessary. NOTE:
The unit may have an inclination of 3/16” (5.0
mm) maximum without affecting performance.
5. Once level, hand tighten the front leg retaining
nuts. Tighten them into place using a crescent
wrench.
1/8” (3.0 mm)