Filter
Top Products
7
Installation Instructions
Verify the Package Contents
• Remove all styrofoam and plastic wrap from the
dishwasher. Be sure to remove the toe kick from
the top of the dishwasher packaging. With the
assistance of at least one person, remove the
dishwasher from the shipping pallet. Place the
unit to the side of the cabinet opening. NOTE:
Since each dishwasher is tested at the factory
for proper operation, there may be some residual
water inside the unit, the water supply line or
drain hose.
• Remove the “O” ring attached to the water line
in a plastic bag. Set it aside for use during the
Water Line Connection.
• Remove all of the packing materials from inside
and outside of the unit. DO NOT allow any of
the shipping materials, loose screws or plastic to
remain inside.
• Verify that all required components have been
provided. Inspect the unit for shipping damage
(including cosmetic damage). If any item is
missing or damaged, please contact your
dealer immediately. Do not install a damaged or
incomplete appliance.
Included:
Toe kick
Mounting hardware
(2 screws, 2 spacers)
Plastic feet (3)
O ring (comes attached to the water line)
Product literature
Tools required for installation:
Level
Crescent wrench
Wire strippers (permanent electrical
connections only)
Flat blade screwdriver
Phillips screwdriver (#2)
Tape measure
Electric drill with 1 1/2” and 2” drill bits
Materials required for installation (not provided)
Hose clamp (select the correct size clamp for
the drain connection...see facing page).
Additional hose and clamps may be required for
installation of an air gap according to local code.
Make sure you have everything necessary for proper
installation before proceeding.
A
B
C
D
E
F
G
H
J
K
L
M
A
N
M
C
D
E
F
H
G
J
K
B
L
N