Filter
Top Products
26
Care and Cleaning
Cleaning the Oven Interior (cont.)
Optional Cookie Sheets
Clean the optional aluminum cookie sheets with a solu-
tion of detergent and warm water. Since aluminum can
scratch, you need to use the soft side of a sponge. A way
for you to keep cookie sheets cleaner is to use parchment
paper over the cooking surface during baking. The parch-
ment paper will also prevent food from sticking.
Optional Baking Stone
Wash the optional baking stone with hot water and scrub
it clean before you use it for the first time. Do not use any
soap or detergents to wash the it. The stone is porous and
soap will get trapped inside. The trapped soap will affect
the flavor of the food cooked on it. Do not be alarmed
if the stone gets stains on it after it is used for a while.
Stains do not affect the stone’s ability to bake properly.
When you need to remove large food particles from the
baking stone, use warm water and a scrub brush. If there
is a lot of oil build-up, it may smoke and create odors. If
you need to remove the oily build up, use a scouring pad
or brush to remove it. You may also use a paste of baking
soda and water to scrub off small stains.
Replacing the Light Bulb(s)
WARNING
• To prevent electrical shock and/or personal injury,
make certain that the oven and light bulb are cool
and that power to the range has been turned off
at the circuit breaker panel or fuse box before
replacing the light bulb.
• Always make sure the lens cover is in place when
using the oven. The lens cover protects the bulb
from breakage.
• Replacing the lens cover without lining up the cutout
with the light socket will damage the light fixture.
• Do not use a screwdriver to remove the lens.
• Light bulb replacement is considered a homeowner
maintenance operation. If the light does not work,
before replacing it, please consult the Problem Solu-
tion Guide on page 28.
• Replace the light bulb only with Dacor part number
107112. See the facing page for ordering information.
IMPORTANT
Do not touch the replacement halogen light bulb with
your fingers. Halogen bulbs are sensitive to the oils
from your hand. The oils from your hand will stick to the
bulb and may cause it to burn out faster than normal.
To replace a light bulb, follow these steps:
1. Turn off power to the range at the circuit breaker
panel or fuse box.
2. Hold your hand under the lens for support and gently
pry it loose using a spatula or table knife. Pull the lens
cover straight out.
3. Grasp the old bulb and pull it straight out of the
socket.
4. Using a glove, insert the new bulb into the socket.
5. As you reinstall the lens cover, line up the cutout on
the inside rim with the light socket. Gently press it
into its original position.
6. Turn the power to the range back on. Reset the clock
(see page 9).
Light fixture
in oven wall
Light
socket
Lens
Lens
cutout
Light bulb