Filter
Top Products
9
To Remove and Replace the Ice Storage Bin
(dispensing models):
Hold the base of the storage bin (located on the back of the 1.
freezer door) with both hands and press the release button to
lift the storage bin up and out.
NOTE: It is not necessary to turn the ice maker control to
the OFF (right) position when removing the storage bin. The
sensor cover (“flipper door”) on the left wall of the freezer
stops the ice maker from producing ice if the door is open or
the storage bin is removed.
Replace the storage bin on the door and push down to make 2.
sure it is securely in place.
Clean the Ice Storage Bin
Empty the ice container. Use warm water to melt the ice if 1.
necessary.
NOTE: Do not use anything sharp to break up the ice in the
bin or bucket. This can cause damage to the ice container and
the dispenser mechanism.
Wash ice bin with a mild detergent, rinse well and dry 2.
thoroughly. Do not use harsh or abrasive cleaners or solvents.
IMPORTANT:
Allow 24 hours to produce the first batch of ice. Allow 3 days
to completely fill ice container. Discard the first three batches
of ice produced to avoid impurities that may be flushed out of
the system.
The quality of your ice will be only as good as the quality of
the water supplied to your ice maker.
Avoid connecting the ice maker to a softened water supply.
Water softener chemicals (such as salt) can damage parts of
the ice maker and lead to poor quality ice. If a softened water
supply cannot be avoided, make sure the water softener is
operating properly and is well maintained.
It is normal for the ice cubes to be attached at the corners.
They will break apart easily.
For non-dispensing models, do not force the ice maker wire
shutoff arm up or down.
Do not store anything on top of the ice maker or in the ice
storage bin/bucket.
Refrigerator Operation
To Remove and Replace the Ice Bin (non-dispensing
models):
Flip up the ice maker cover.1.
Lift the wire shutoff arm so it clicks into the off (up) position. 2.
Ice can still be dispensed, but no more can be made.
Lift up the front of the storage bin and pull the ice bin forward.3.
Replace the bin by pushing it in all the way or the dispenser 4.
will not work. Push the wire shutoff arm down to the on
position to restart ice production. Make sure the door is closed
tightly.
Dispensing Models
To Turn the Ice Maker On/Off:
The On/Off switch is located on the top right side of the freezer 1.
compartment.
To turn the ice maker on, slide the control to the 2. ON (left)
position.
NOTE: Your ice maker has an automatic shutoff. The ice
maker sensors will automatically stop ice production, but the
control will remain in the ON (left) position.
To manually turn the ice maker off, slide the control to the 3. OFF
(right) position.
A
B
A. Ice maker cover
B. Ice bin
Ice Maker