Filter
Top Products
3
Clean Before Using
After you remove all of the packaging materials, clean the inside
of your refrigerator before using it. See the cleaning instructions in
Care and Cleaning.
Important information to know about glass shelves and
covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
For your protection, tempered glass is designed to shatter into
many small, pebble-size pieces. This is normal. Glass shelves
and covers are heavy. Use special care when removing them to
avoid impact from dropping.
Turning the Main Power Switch On/Off
If you need to turn the power to your refrigerator on or off,
you must remove the top grille assembly to access the power
switch. Turn the power to the refrigerator off when cleaning your
refrigerator or changing light bulbs.
Remove the Packaging
If the ice storage bin is located on the door, remove the
temporary shield from underneath the ice storage bin. See Ice
Maker and Storage Bin.
Remove tape and glue residue from surfaces before turning on
the refrigerator. Rub a small amount of liquid dish soap over
the adhesive with your fingers. Wipe with warm water and dry.
Do not use sharp instruments, rubbing alcohol, flammable
fluids or abrasive cleaners to remove tape or glue. These
products can damage the surface of your refrigerator. For
more information, see Important Safety Instructions on page 1.
Dispose of/recycle all packaging materials.
Before Use
Refrigerator Operation
Removing the Top Grille
Grasp both ends of the top grille.1.
Push the top grille straight up, then pull straight out. Lay the 2.
grille on a soft surface.
Replacing the Top Grille
Insert the top grille hooks (located on the back of the top grille) 1.
into the slots on the side trim.
Pull the grille down slightly to lock into place.2.
To Turn the Main Power Switch On or Off:
Remove the top grille.1.
Press the main power switch to the 2. ON or OFF position.
Replace the top grille.3.
A. Top grille
B. Cabinet side trim
B BA
A. Power switch
A
IMPORTANT: Be sure the main
power switch is set to the On
position after cleaning refrigerator or
changing light bulbs.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from refrigerator.
Failure to do so can result in death, explosion, or fire.