Filter
Top Products
18
Rinse agent dispenser
We highly recommend the regular use of liquid rinse agent to give the best drying results.
Rinse agent gives a streak-free, sparkling clean look to glass and chinaware. In addition, it
prevents metal from tarnishing. The rinse agent dispenser is on the inside of the drawer, located
underneath the detergent dispenser. The rinse agent dispenser holds approximately 1.7fl oz (50
ml) of rinse agent.
Filling the rinse agent dispenser
1
Turn the plug counter-clockwise and remove.
2
Pour the rinse agent into the circular opening.
3
Take care not to spill rinse agent into the
DishDrawer®. Any spillages must be wiped up to
prevent excess foaming. Failure to wipe rinse agent
spillages may result in a service call which will not be
covered by warranty.
4
Fit the plug back into the original position.
How much rinse agent to use
The regulator may need adjusting to suit your water conditions. The lowest setting is ‘1’ and
the highest is ‘5’. Refer to the ‘Option adjustments’ section to adjust the rinse agent setting. If
there is excessive foam at the end of the wash, reduce the setting. If dishes are wet or streaky
after drying, increase the setting.
Rinse agent indicator light
If the rinse agent indicator light is red, refill the dispenser. If the rinse agent indicator light is
dimly lit or not lit at all, there is enough rinse agent for the wash.
Note:
Lighter colored rinse agents will not dim the indicator light as effectively as darker colored rinse
agents.
When the rinse agent is being dispensed, you may notice some unusual noises during the wash:
this is normal.
US
CA