Filter
Top Products
PAGE 4 OF 12
Electrical installation.
This appliance must be earthed and the
manufacturer and the seller do not
accept responsibility for any damage due
to incorrect installation or electrical
connection.
• This appliance should not be connected
through an earth leakage system.
Refer to S.A.N.S.10142
• Support the oven in front of the aperture
and make the electrical connection before
installing. This will ensure enough cable
length for subsequent servicing.
Installation
Connection to the power supply
The connection must be carried out by a
licensed electrician, who will ensure that
the oven is correctly connected and safely
earthed. The rated current is printed on the
serial number label attached to the oven
side trim.
The appliance must be connected to the
mains through a double pole isolating
switch which has a minimum clearance
between the contacts of 3 mm. in both
poles.
A means for disconnection must be
provided in the fixed wiring.
1085
Aperture
Typical section showing
ventilation requirements
Aperture
1085 H x 700 W x 580 D
700
600
Above floor
level
Floor
60
+
_
3
0
+
_
3
0
+
_
3
0
+
_
3
0
Aperture
32
32
• Support the oven in front of the aperture
and make the electrical connection before
installing. This will ensure enough cable
length for subsequent servicing.
• Slide the oven fully into the cabinet
before securing it.
100 MIN
• Fixing holes are located on the side trims.
Secure the oven by inserting small wood
screws through these holes into the
cabinet side wall. (screws are not
provided)
• It is adequate to only secure the unit on
one side. (same side as the handle)
100 MIN