Filter
Top Products
PAGE 5 OF 12
This task will require an assistant to hold and support the
door during the changeover
Open the oven door and using a suitable Allen key, remove the
two hinge mounting cover plates (A) located at the top and
bottom of the right hand oven flange.
While holding and supporting the door weighing 7.4kg,
remove the hinges (B) at the left hand oven flange.
DO NOT REMOVE OR LOOSEN THE STAR SCREW IN
THE CENTRE
Using a size 10 spanner, loosen the locknut ( C ) on the door
lock pin .
Then holding the pin by the head, (D), unscrew it from the right
hand oven flange.
Screw the pin into the centre position of the left hand oven
flange and fasten the lock nut.
Turn the door through 180 degrees so that the bottom is now on
top.
While supporting the door, secure the hinges (B) at the vacated
positions (top and bottom) of the right hand oven flange.
Fit the hinge mounting cover plates (A) at the vacated positions
(top and bottom) of the left oven flange.
Loosen nut ( C) and adjust the hinge pin (D) by turning it in or
out until the oven door shuts properly. Thereafter tighten the
lock nut ( C ) once more.
Should you experience difficulty in aligning the door to the
locking pin, loosen the star screw (E) and Allen screws (F)
slightly. (DO NOT REMOVE))
The door can then be maneuvered left to right and top to bottom
to perfect the alignment. Thereafter tighten all the screws.
A
B
C
D
C
D
Reversing the oven door to open from the other side ( optional)
1
2
3
4
5
6
7
8
E F F
9
Should the procedure described above prove to be onerous, a Defy
technician can perform the adjustment at the standard call-out fee.