PAGE 3 OF 16
Permanent installation. Important information for the user.
The appliance may only be installed by a registered LP Gas installer. All registered
installers are issued with a card carrying their registration number. Ask to be shown
this card before allowing the installation to commence and make a note of the installer
QCC number below. Upon completion of the installation, the installer is required to explain
the operational details of the appliance together with the safety instructions. You will be asked
to sign acceptance of the installation and be provided with a completion certificate. You should
only sign for acceptance when the installation is completed to your satisfaction..
(SEE PAGE 16)
Failure to comply with the above will render the warranty invalid.
Note: Your invoice is required in the event of you wishing to make a warranty claim.
Important information for the installer.
This appliance may only be installed by a LP Gas installer registered with the LPGSASA.
(Liquid Petroleum Gas Association of Southern Africa) . The appliance must be installed in
accordance with the requirements of SANS 10087-1 and any fire department regulations and/
or local by-laws applicable to the area. If in doubt check with the relevant authority before
undertaking the installation. Upon completion of the installation you are required to fully
explain and demonstrate to the user the operational details and safety practices applicable to
the appliance and installation including:
a) The position of the isolation or shut-off valve in the gas supply line to the appliance.
b) The requirements for safe operation of the appliance.
Note.This appliance is supplied ex-factory with jets and air settings for use with LP gas
only.
Safety compliance with local requirements.