Filter
Top Products
PAGE 9 OF 16
Cleaning continued
BURNER BODY
BURNER CAP
FLAME FAILURE SENSOR
IGNITION
ELECTRODE
• Carefully align the hole in the burner body
with the flame failure sensor.
• Gently lower the burner body into position.
• Centralise and level the burner cap onto
the burner body. (The burner cap must be
positioned so that it rests centrally on the
burner body). Ensure that it is correctly
seated. Refit the pot stands.
Fitting the burner caps.
Gas Jet Cleaning Procedure
• Every six months the gas jets on your hob
should be cleaned to ensure continued
efficient and safe operation.
• This may be done using a Gas Jet
Cleaning Kit which may be purchased
from your nearest Defy Service Centre.
• The kit comprises of a sliding T-bar (A) a
socket (B) and a ‘Classic pin’ (C).
• Fit the T-bar to the socket and remove
the pot stands, burner caps and burner
bodies.
1. Insert the socket into the central tube of
the burner so that it locates over the
brass gas jet at the bottom of the tube.
2. Gently loosen the brass gas jet by turning
the socket in an anti-clockwise direction.
3. Carefully lift the socket and loosened
brass gas jet from the central burner tube.
4. Insert the Classic pin into central hole of
the jet and slide it up and down until the
jet is free of accumulated dirt.
5. Re-assemble in reverse order.
6. Clean all the burner jets in the manner
described above.