Filter
Top Products
PAGE 5 OF 16
Electrical connection
This appliance must be earthed and the manufacturer and the seller
do not accept responsibility for any damage due to incorrect
installation or electrical connection.
The mains supply must correspond with the data specified on the
rating plate located on the base of the hob.
• The Gas hob requires an electrical connection for the flame ignition system and is fitted
with a 15 Amp 3 pin plug.
• Insert the plug into an earthed 15 Amp wall socket which is easily accessible but not
located directly above the hob.
• The mains lead must not be clamped, bent or trapped. Nor should it come into contact with
hot parts of the hob. If the mains lead is damaged it should be replaced by a qualified
electrician. The mains lead is a type 3x0.5mm² H05VV-F.
• The appliance is not intended to be operated by means of an external timer or separate
remote-control system.
Gas connection
This appliance uses LPG ( Liquid petroleum or bottle gas)
This appliance requires an operating pressure of 2.8 –3.0 kPa at the appliance. A
suitable LPG regulator that complies with the requirements of SANS 1237 must be used.
The manufacturer and the seller do not accept responsibility for any damage due to
incorrect installation or gas connection.
Flexible hose - Not supplied. Any hose that is used to connect the stove to the gas system
shall comply with SANS 1156-2 or BS 3212.
Ensure that pipe clamps are tightened correctly and are of good quality.
Gas cylinder - Not supplied.. For best results we recommend that gas cylinders with a
minimum capacity of 19kg be used.
Regulator - Not supplied. A 2,8 kPa LPG gas regulator which complies with SANS 1237
must be used.
Temporary installation.
A flexible hose connection from the gas appliance to the cylinder can be made.
Ensure that pipe clamps are tightened correctly and are of good quality.
• Gas bottles should be located outdoors in a suitable ventilated lock-up.
• The connecting hose should not exceed 125 cm in length.
• Soak the end of the flexible hose in hot water to soften it and then push the hose end fully
over the hose nozzle
• Secure the hose by tightening the hose clamp.
• In a similar fashion, secure the other end of the hose to the regulator on the gas cylinder.
See sketch on next page.